N24 Specification Aston Martin V8 Vantage N24 The specification is based on a standard production, European specification (left hand drive), V8 Vantage with the following modifications: Body FIA approved full roll cage in 40mm x 1.5mm 15CDV6 high strength steel Preparation for pneumatic jacks incorporating tapping plates Motor sport towing eyes Plastic side & rear windows – with slide opening on driver's side Re-styled side sill with exposed carbon fibre rib Quick release bonnet/tail safety latching with hinges retained Lightweight aluminium side strakes

Engine & Transmission Cylinder heads re-profiled, smoothed inlet & exhaust ports and optimised compression ratio Crankshaft, conrods, pistons and flywheel lightened and balanced to race standards ITG cylindrical foam air filters Reduced cell density primary catalysts Revised engine calibration (97 RON fuel) EGR & secondary air system removed Simplified oil breather system with catch tank Weight reduced rear muffler without by-pass valves Air conditioning system and compressor removed FIA approved ATL bag type fuel tank with twin fuel pumps -100L capacity. Filling point built into the right hand C-post with facility to accept a quick fill 'dry break' arrangement Standard 6-speed manual transmission – fitted with breather catch tank Valeo twin plate cerametallic clutch (215mm) with lightweight flywheel

Underframe Single rate, flat ground, 2.5" ID. Eibach springs with separate helper springs. Stiffened diameter front and rear anti-roll bars Dynamic Suspensions adjustable ride height aluminium dampers Front subframe modified for extra camber and castor Wheels & Tyres Speedline Corse 10" X 18" ET45mm cast magnesium front wheels 5 x 114.3 PCD Speedline Corse 11" X 18" ET48mm cast magnesium rear wheels 5 x 114.3 PCD Yokohama A048 tyres 250/650 18" front, 280/650 18" rear Standard radial-mounted 4 piston monobloc callipers fitted with high performance Pagid RS 29 race pads Electrical Reduced weight and optimised route wiring harness Optima gel battery Battery cut off relay New switch panel mounted in centre console (includes; re-settable circuit breakers for each fuel pump, extinguisher button, battery cut-off button, heater controls, mirror switch and toggle switches for fog lights, hazard lights, traction control and heated front screen. Panel graphics illuminated by 'electroluminescent' film Original V8 Vantage instrument pack All other standard production ancillary electrical systems removed Interior Recaro Pole Position competition shell seat with Aston Martin wings logo Schroth 6 point safety harness – push button release FIA compliant Lifeline Zero 360 plumbed in extinguisher system (gas) – 4 engine bay and 2 interior nozzles Raised driver's footrest New simple door casings moulded in 'Twintex' for weight saving and compatibility with roll cage Weight reduced facia, trimmed in Alcantara Shortened one piece carbon fibre centre console Quick release suede trimmed steering wheel All other standard production trim and airbags removed

Options Passenger seat and safety harness Uprated front brake kit Two-way adjustable dampers Automated manual Sportshift transmission Dry break fuel filler Dual fuel filler HANS seat and safety harness Air jacks including lance Pair of N24 xenon spot lights Dimensions & Performance Length: 4380mm (172.5 in) Height: 1210mm (47.5 in) Width: 1865mm (73.5 in) (exc. Mirrors) 2025mm (80 in) (inc. Mirrors) Wheelbase: 2600mm (102.5 in) Front Track: 1580mm (62.2 in) Rear Track: 1590mm (62.6 in) Kerb Weight (less fuel): 1330kg Fuel Tank Capacity: 100 litres Maximum Power: 410bhp (305kW) Maximum Torque: 313lb.ft (425Nm)